Maintenance Of Silk'n Flash&Go; Cleaning Silk'n Flash&Go; Replacing The Lamp Cartridge - Silk'n Flash&Go Bedienungsanleitung

10. Maintenance of Silk'n Flash&Go™
10.1. Cleaning Silk'n™ Flash&Go
After each hair removal session, it is recommended to clean your Silk'n Flash&Go™ device, and especially the
Treatment Surface.
Unplug Silk'n Flash&Go™ before cleaning.
Use a dry, clean cloth and a specially formulated cleaner for electronic equipment to gently wipe Silk'n
Flash&Go™ surface, and especially the Treatment Surface.
Never immerse Silk'n Flash&Go™ or any of its parts in water!

10.2. Replacing the Lamp Cartridge

The Silk'n Flash&Go™ DISPOSABLE LAMP CARTRIDGE can fire a pre-set and limited number of light pulses.
Pulse intensity is determined only according to the energy level setting of the device. There is no decrease of
energy during the usable lifetime of the LAMP CARTRIDGE.
When only 100 light pulses remain in the DISPOSABLE LAMP CARTRIDGE, the REPLACE CARTRIDGE
INDICATOR LIGHT on the CONTROL PANEL will start blinking, indicating that the DISPOSABLE LAMP
CARTRIDGE should soon be replaced.
As the number of light pulses in the DISPOSABLE LAMP CARTRIDGE further decreases, the REPLACE
CARTRIDGE INDICATOR LIGHT blinking will grow faster.
Once all the pulses in a DISPOSABLE LAMP CARTRIDGE have been used, the REPLACE CARTRIDGE
INDICATOR LIGHT will remain steadily on, indicating that further pulses cannot be emitted.
In order to continue the hair removal session, it will now be necessary to replace the DISPOSABLE LAMP
CARTRIDGE.
Note: A DISPOSABLE LAMP CARTRIDGE should also be replaced if large spots
appear inside it or if its TREATMENT SURFACE is broken.
To replace a DISPOSABLE LAMP CARTRIDGE:
1. Press the ON/STBY SWITCH to turn Silk'n Flash&Go™ to Stby mode.
2. Unplug the power adaptor from the electrical outlet.
3. Grasp the used DISPOSABLE LAMP CARTRIDGE on both sides, pull it out of the socket and discard with normal trash.
4. Unwrap a new DISPOSABLE LAMP CARTRIDGE.
5. Push the new DISPOSABLE LAMP CARTRIDGE gently into place.
Note! After replacing the disposable lamp cartridge with a new one, always set the energy to be one level lower
than your normal setting. Raise the energy level back, only if you do not experience abnormal discomfort during
or after the treatment.
14
Downloaded from www.Manualslib.com manuals search engine