Troubleshooting - Electrolux TWSL5E300 Benutzerinformation

12. TROUBLESHOOTING

The tumble dry‐
er does not op‐
erate.
Unsatisfactory
drying result.
The loading
door does not
close
Not possible to
change the
program or op‐
tion.
Downloaded from www.Manualslib.com
1)
Problem
The tumble dryer is not connec‐
ted to the mains supply.
The door is open.
The On/Off (Ein/Aus) button
was not pushed.
The
not touched.
The appliance is in standby
mode.
Incorrect program selection.
The filter is clogged.
Dryness (Trockengrad) op‐
tion was set to
geltrocken) .
The load was too large.
The airflow slots are clogged.
Dirt on the humidity sensor in the
drum.
Dryness level not set to desired
level.
The condenser is clogged.
The filter is not locked into posi‐
tion.
Laundry is trapped between the
door and the seal.
After cycle start it is not possible
to change the program or option.
manuals search engine
Possible cause
Start/Pause button was
iron dry (Bü‐
4)
ENGLISH
Remedy
Connect to the mains socket.
Check fuse in fuse box (domes‐
tic installation).
Close the door.
Push the On/Off (Ein/Aus)
button.
Touch the Start/Pause but‐
ton.
Push the On/Off (Ein/Aus)
button.
Select a suitable program.
3)
Clean the filter.
Change Dryness (Trocken‐
grad) option to higher level.
Do not exceed the maximum
load size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
3)
Clean the condenser.
Put the filter in the correct posi‐
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option
as required.
23
2)
5)