What To Do If; Troubleshooting By Yourself - Electrolux TW SL EEV Benutzerinformation

72 electrolux

WHAT TO DO IF ...

Troubleshooting by yourself

1)
Problem
Dryer not connected to mains supply.
Dryer does
not work. Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
does not Filters not locked in place.
close
Err (Error) on
Attempt to change parameters after
5)
start of the programme.
the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis
elapsing time
of: type, volume and dampness of laun-
5)
dry.
on the LCD
Programme
Full water reservoir.
inactive
Possible cause
1
6
9
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter
into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to DRUM LIGHT (if available) or
to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty water reservoir
PAUSE button.
2 3
4 5
7 8
10 11
Remedy
2)
3)
3)
4)
.
3)
, press START