Herunterladen Inhalt Inhalt Diese Seite drucken

Clean Operating Screen And Housing; What To Do If; Troubleshooting By Yourself - Electrolux EDH97961W Benutzerhandbuch

Vorschau ausblenden Andere Handbücher für EDH97961W:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Keep the inner surface of the drum and
the drum blades clean. The minerals
from the water or cleaning agents can
collect on the inner surface of the
drum. This cause that the laundry is not
sufficient dry.

WHAT TO DO IF ...

Troubleshooting by yourself

1)
Problem
Dryer not connected to mains supply.
Dryer does
not work.
Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err ( Error )
Attempt to change parameters after
5)
start of the programme.
on the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis
elapsing time
of: type, volume and dampness of laun-
5)
dry.
on the LCD
Programme
Full water reservoir.
inactive
Drying cycle
Small laundry volume./Too dry laundry
to short
for selected programme.
Fluff filters clogged.
Drying cycle
To high loading volume.
6)
to long
Laundry insufficiently spun.
Possible cause

Clean operating screen and housing

Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the appliance.
Use a damp cloth to wipe down the op-
erating screen and housing.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter
into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to DRUM LIGHT (if available) or
to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty water reservoir
PAUSE button.
Select time programme or higher drying
level (e.g. EXTRA DRY ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
electrolux 67
Remedy
2)
3)
3)
4)
.
3)
, press START

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis