Changing The Battery Unit - Siko AP10S Originalmontageanleitung

AP10S
34 Battery change
CAUTION

6.3 Changing the battery unit

Position indicator failure
Improper installation results in loss of type of protection.
` Evenly tighten the screws
aligned with the LCD housing
` Check the correct position of the O-ring
Preparation:
1. Connect position indicator to supply voltage.
2. Place the replacement battery unit ready (see chapter 6.1).
3. Place a Phillips screwdriver ready (e. g. PH 0x60).
Deinstallation (see Fig.
1. The battery compartment is situated on the left side of the device
(connections below).
2. Unscrew 3 fastening screws
3. Take out the battery unit
battery).
Installation (see Fig.
1. Insert new battery unit
2. Check the correct position of the O ring
tery unit, the O-ring must lie all round the battery housing.
2



Fig. 8: Battery change
AP10S · Date 19.05.2016 · Art. No. 87100 · Mod. status 154/16
1 until the battery unit
.
4
8):
1 .
(refer to chapter
2
8):
. Take care that it can be inserted easily.
2

English
2 is completely
.
3
7
for disposal of the old
3 . When mounting the bat-
Screw
1
Battery unit
2
3 O ring
Housing
4