Cleaning And Care - Silvercrest SSM 200 A1 Bedienungsanleitung

6) Applying light pressure, use the pusher 6 to
push the fruit into the appliance. The chopped
GB
fruit will come out of the outlet 9 after a short
time. If the pusher 6 cannot be pressed further
down, remove it and add a little more fruit or
ingredients.
NOTE
► If you want to make a sorbet from several
diff erent fruits/ingredients, add the diff erent
fruits alternately into the feed tube 2. In this
way, the fruits will be mixed directly.
7) Once all the fruits are chopped, stop the appli-
ance by moving the on/off switch 1 to the O
position.
8) Remove the power plug from the socket.
9) Unscrew the end cap 8 and pull the blade
roller 5 carefully out of the roller housing 3.
10) Use a knife to scrape any remaining fruit
residue from between the blades on the blade
roller 5 and add this to the bowl.
11) Mix the fruit in the bowl.
You can now serve the sorbet.
6
Downloaded from www.Manualslib.com manuals search engine

Cleaning and care

RISK OF ELECTRIC SHOCK
► Always remove the plug from the mains power
socket before you clean the appliance.
Ensure you never submerse the motor unit 0
in liquid, and never allow liquid to enter the
motor unit housing 0.
WARNING! RISK OF INJURY!
► Take great care when handling the blade
roller 5.
Clean the motor unit 0 with a moist cloth after
♦
every use . If there is heavy soiling, add mild
detergent to the cloth. Rinse detergent residues
off with clear water. Ensure that there are no
detergent residues on the appliance, and that the
appliance is completely dry before renewed use.
Remove the pusher lid 7 from the pusher 6 for
♦
cleaning purposes.
Wash the pusher 6, the pusher lid 7, the
♦
blade roller 5, the end cap 8 and the roller
housing 3 in lukewarm water with a little
detergent.
♦ Ensure that all parts are completely dry before
re-use.
NOTE
You can also wash the pusher 6, the pusher
►
lid 7, the end cap 8 and the roller housing 3
in the dishwasher.
Place the parts, where possible, in the upper
basket and ensure that none of the parts can
get stuck. Otherwise they could get bent or
otherwise deformed.
SSM 200 A1