Changing Password - Roger Technology B70/1DC Anweisungen Und Hinweise Für Den Installateur

View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvres performed.
Example:
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvre hours.
Example:
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on.
Example:
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (
Only a single password is used to control access to the gate automation system.
WARNING: Contact the Technical Support Service if you lose your password.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP
• Press and hold the + and - buttons for 4 seconds.
•
• Switch the control unit off and on again. Check that password protection is activated ( =
Temporary unlock procedure:
• Enter the password.
• Check that
Password cancellation procedure:
• Enter the password (
• Save the values
• Use the UP
• Press and hold the + and - buttons for 4 seconds.
•
indicate that no password is set).
• Switch the control unit off and on again.

Changing password

Protection deactivated.
Protection activated.
82
x100 = 1.234.500 manoeuvres.
= 123 hours.
= 123 days.
=
,
buttons to view the parameter
and/or DOWN
= .
= ).
, , , =
buttons to view the parameter
and/or DOWN
to multiplied by 100.
to .
to .
, and .
.
.
).
, , and