Dimensions - Panasonic S-80MW1E5 Installationsanleitung

2-1. Exposed type
Preparation: Make 2 holes for screws using a screwdriver.
3 Mount the top case.
● A lign the claws of the top
case and then align the
claws of the bottom case.
Cut here with
a nipper and
remove the burr
with a file.
2 Connect the remote control wiring
● A rrange the wires along the groove of the case.
2-2. Embedded type
Preparation: Make 2 holes for screws using a screwdriver.
3 Mount the top case.
● A lign the claws of the
top case and then
align the claws of the
bottom case.
Avoid the
wire being
caught.
Claw
(2 places)
2 Connect the remote control wiring

6-3. Dimensions

120
120
1 Mount the bottom case to the wall.
Claw
(2 places)
Hole for
screw
Claw
Wood screw
(2 places)
(supplied)
1 Mount the bottom case to the wall.
● P ass the wire through the hole in the centre of
the bottom case.
Hole for
screw
Claw
Wood screw
(2 places)
(supplied)
23 23
16
(Unit: mm)
Wall to which
the remote
controller is
fixed
Top case
Bottom case
(Back side)
(Back side)
Bottom case
(Back side)
5-5x9
18
Clamper
(supplied)
Pass through
the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 180 mm
Make sure the wiring connection is in
the correct direction.
Remote controller terminal board
Top case
Remove the coating. Approx. 6 mm
(Back side)
Make sure the wiring connection is
in the correct direction.