Frequently Asked Questions (Faqs); Technical Specifications - Marmitek MegaView 60 Gebrauchsanleitung

Frequently asked questions (FAQs)

Bad (or no) image and sound
• Ensure that the CAT5e/6 cables are connected correctly between the
MegaView60/61 transmitter and receiver (CAT5e-1 to CAT5e-1 and CAT5e-2 to
CAT5e-2).
• Check if the A/V device is switched on.
• Use only CAT5e/CAT6 cable as specified in chapter 3 (CAT5e Cable
Requirements).
• Check if the CAT5e/CAT6 cable provides a solid connection (no cable faults).
• Check if the RJ-45 has been connected according to the EIA/TIA T568B standard.
Please refer to attachment page XX
• Please ensure that the maximum cable length is not exceeded.
• Install your system as far away from any RF sources (wireless devices) as
possible.
• Set a low resolution on your HDMI source. The CAT5e/6 cable used probably
cannot deal with the higher resolution bandwidth.
Do you have any questions that are not answered above?
Please check www.marmitek.com.

Technical specifications

Resolution
Supported HDTV Resolutions
Single link Bit Rate (max)
Supported Standards HDMI
Transmitter
HDMI input (19-pin female)
Video signal input
DDC signal input
Receiver
HDMI output (19-pin female)
Video output
CAT5e/6 cable length (max.)
Transmitter/Receiver
Dimensions (H x B x D)
Weight
Environment
Ambient temperature
Ambient humidity
Power
Input
Output
Specifications may be modified without prior notice.
6
480p, 576i, 576p, 720p, 1080i, 1080p
1.65 Gbps
DVI, HDCP
1 HDMI
0.5 – 1.0V p-p
5V p-p
1 HDMI
HDMI V1.2a
60m for 480p and 30m for 1080p (MegaView60)
45mm x 25mm x 81mm
246g
+0 to +70° C
10% to 85%
100-240VAC @50-60Hz
5VDC 2A
© MARMITEK