Switching On The Appliance; Operating Tips - Bosch KGF Serie Gebrauchsanleitung

Controls
Fig. 2
1 On/Off button
Serves to switch the whole
appliance on and off.
Alarm button
2
Used to switch off the warning
signal, see chapter "Alarm
function".
3 "Super" button (freezer
compartment)
Switches super freezing
on and off.
4 Temperature selection button
freezer compartment
The button sets the temperature
in the freezer compartment.
5 Temperature display freezer
compartment
The numbers correspond
to the set freezer compartment
temperatures in °C.
6 "Super" button refrigerator
compartment
Switches super cooling on and
off.
7 Selection button for refrigerator
compartment
Is used to set the temperature
in the refrigerator compartment.
8 Temperature display refrigerator
compartment
The numbers correspond
to the set refrigerator
compartment temperatures in °C.
ON/OFF display
9
The ON/OFF display is lit when
the appliance is in operation.
Switching on
the appliance
Switch on the appliance with the On/Off
button, Fig. 2/1. The temperature
warning signal is switched off by
pressing the alarm button, Fig. 2/2.
The temperature displays flash
and the alarm button display is lit up,
until the appliance has reached the set
temperatures.
The light in the refrigerator compartment
is lit when the door is open.
The factory has recommended
the following temperatures:
Refrigerator compartment: +4 °C
■
Cool-fresh compartment: at almost
■
0 °C
Freezer compartment: –18 °C
■
Note
If the light switch, Fig. 1/10, is pressed
when the door is open, the light and the
displays on the controls go out.

Operating tips

When the appliance has been
■
switched on, it may take several hours
until the set temperatures have been
reached.
The fully automatic No Frost system
■
ensures that the freezer compartment
remains free of ice. Defrosting is no
longer required.
The sides of the housing are
■
sometimes heated slightly. This
prevents condensation in the area of
the door seal.
If the freezer compartment door
■
cannot be immediately re-opened after
it has been closed, wait until the
resulting low pressure has equalised.
en
29