Wireless Shutter Release Mode; Setting The Camera - Walimex Pro W1 TTL Gebrauchsanleitung

1. Press the <CH/OK> Button for 2 seconds or longer until <Fn> is displayed.
2. Select the custom function No.
* Turn the Select Dial to choose the Custom Function No.
3. Change the Setting.
* Press the <GR> Button until the custom function No. blinks.
* Turn the Select Dial to set the desired number. Pressing <GR> button will confirm
* Press <MODE> button to exit the C.Fn settings.

7.14 Wireless shutter release mode

Half press the <TEST> Trigger Button to focus. Fully press the <TEST> Trigger
Button, and the Status Indicator Lamp turns red. Now camera is ready to shoot.
When releasing the button, the Status Indicator Lamp turns off.

7.15 Setting the Camera

Use the External Flash Function on the camera to do the setting.
1. GR mode can only be used normally when attaching to the CANON EOS ca-
2. In the NON-GR mode, Ration Off is steadily set in the TTL mode while A:B C is
W1 TTL T-C cannot be triggered when the camera is set to wireless lighting mode (WL).
41
701_walimex pro Funkauslöser W1 TTL T-C_BDA.indd 41
Downloaded from www.Manualslib.com
the settings.
NOTICE
meras that issued after 2012. If the camera model do not support GR grouping
flash mode, NON GR mode will be changed automatically.
steadily set in the M mode.
Flash Mode
Fill flash
-
SLOW
REAR
WL
manuals search engine
Flash Mode
Wireless
SLOW
REAR
WL
3/12/2018 1:15:17 PM