Fitting The Hood - Atag WS90MM Serie Gebrauchsanweisung/Installationsvorschrift

assembly
(continued)
Suspend the motor module on the threaded ends (1). Screw
the nuts on. Make sure that the motor module is exactly level.
1
Drill holes (2 x ø 6 mm) and secure the motor module with the
fixing pins supplied (6 x 60) (2).
Fit the discharge duct.
2
Connect the motor module electrically.

fitting the hood

Fit the hood to the motor module. First hook the rear of the
hood into the motor module at the bottom (1).
Then lift the front up (2) so that the two bolts supplied (M5 x
12) can be screwed in (3). Use these bolts to level the hood.
Use these screws to level the hood.
1
Make the plug connections in the hood.
3
2
GB 12 GB 12
assembly
(continued)
fitting the telescopic pipe
NB: During recirculation, the ventilation slits must not be
covered by the lower telescopic pipe.
Slide the flanged end of the upper telescopic pipe upwards
between the fixing bracket and the wall, and slide the
telescopic pipe against the ceiling. The telescopic pipe locks
into position.
Hook the lower telescopic pipe onto the upper part and
allow the lower part to drop so that it slides into the edge of
the hood.
Put the filters in place and test the extractor hood.
GB 13