Fitting The Hood - Atag WG8..B Centur serie Gebrauchsanweisung/Installationsvorschrift

assembly
(continued)
20
1
2
1
2
2
marking out and fitting motor module
Mark the position of the underside of the hood on the wall
(bear in mind the minimum distance to the hob). Mark the
(vertical) centre line.
Fold or cut the template depending on type and mark the
upper fixing holes.
Drill the fixing holes (2 x ø 10 mm).
Fix the plugs. Screw two nuts onto the threaded ends in the
opposite direction. Screw the threaded ends into the wall
leaving 20 mm projecting (see illustration).
Remove the nuts.
Suspend the motor module on the threaded ends (1). Screw
the nuts on. Make sure that the motor module is exactly level.
Drill the holes (2 x ø 6 mm) and fit the fixing brackets with
the fixing pins supplied 6 x 60 mm (2), thereby also securing
the motor module.
Fit the discharge duct.
Connect the motor module electrically.

fitting the hood

Slide the top of the hood over the motor module (1). Screw
the hood to the motor module using the screws supplied
4.2 x 9.5 mm (4x) (2).
WG7
Attention: slide the connecting bar for the valve between the
adjusting bracket and the suspension module (see
'assembling the connecting bar').
GB 11