GYS GYSCAP 680 E Bedienungsanleitung Seite 12

When all bars are displayed the GYSCAP 680E is ready for further troubleshooting.
After switching off the GYSCAP 680E with the button
Disconnect the GYSCAP 680E clamps from the vehicle.
Wrap the cables and store the clamps in the space provided.
CIGARETTE LIGHTER CHARGING
To facilitate recharging, the GYSCAP 680E is delivered with a cable to connect directly to the vehicle's cigarette lighter
socket. It is then possible to optimally recharge the GYSCAP 680E in a few tens of minutes.
i
This method is recommended for an additional load. In case the GYSCAP 680E is com-
pletely discharged, it is quicker to connect to the battery of an operational vehicle.
Additional charge: 20 minutes
Full Charge: 4 Hours
Connect the GYSCAP 680E cigarette lighter cable to a vehicle.
The bars on the digital display increment, the GYSCAP 680E recharges.
- The additional charge is completed in a few tens of minutes.
- The complete recharge is done in a few hours.
The digital display shows «End» and «CH» simultaneously. The GYSCAP 680E is ready for further
troubleshooting.
GYSCAP 680E is loaded.
Unplug the cigarette lighter plug to turn off the GYSCAP 680E.
STARTER OPERATION
During standard troubleshooting :
Connect the clamps of the GYSCAP 680E to the vehicle to be repaired, respecting the polarity.
Press the Power button.
The digital display shows the capacity status of the GYSCAP 680E.
Battery status display: voltage at the end of the clamps.
12
GYSCAP 680E
:
EN