20 www.electrolux.com
Downloaded from
www.Manualslib.com
CAUTION!
If a hob is installed with the appli-
ance, do not use it at the same
times as the Pyrolysis function. It
can cause damage to the appli-
ance.
1.
Remove the removable shelf supports
(if applicable) and accessories from
the appliance. Refer to "Removing the
shelf supports".
CAUTION!
Do not let the removable shelf
supports stay in the appliance
during the cleaning procedure.
There is a risk of damage.
2.
Remove the worst dirt manually.
3.
Fully close the oven door.
The cleaning procedure cannot
start if you do not close the oven
door.
4.
Set the function Pyrolysis. Refer to
"Oven functions".
5.
When
flashes, press + or - to set
the necessary procedure:
– P1 - if the oven is not very dirty.
The procedure is 1 h long.
– P2 - if the oven is more dirty. The
procedure is 1 h 30 min long.
6.
Press
to start the procedure. You
can use the End function to delay the
start of the cleaning.
When the oven is at the set tempera-
ture, the door locks. The display
shows the symbol
the heat indicator.
To stop Pyrolysis before it is com-
pleted, turn the knob for the oven
functions to the off position.
When Pyrolysis is completed, the display
shows the time of day. The oven door
stays locked. When the appliance is cool
again, an acoustic signal sounds and the
door unlocks.
During the Pyrolysis the oven
lamp is off.
Cleaning reminder
To remind you that Pyrolysis is necessary,
PYR flashes in the display for 10 seconds
manuals search engine
after each activation and deactivation of
the appliance.
The cleaning reminder goes off the
display:
• After the end of the Pyrolysis function
• If you press + and - at the same time
while PYR flashes in the display.
9.3 Oven lamp
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or
deactivate the circuit breaker.
1.
2.
3.
4.
and the bars of
9.4 Cleaning the oven door
The oven door has four glass panels. You
can remove the oven door and the inter-
nal glass panels to clean them.
Do not use the appliance without the
glass panels.
WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.
Put a cloth on the bottom of the
oven to prevent damage to the
oven light and glass cover.
Always hold the halogen lamp
with a cloth to prevent grease res-
idue from burning on the lamp.
Turn the glass cover counterclock-
wise to remove it.
Clean the glass cover.
Replace the oven light bulb with an
applicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
Install the glass cover.
The oven door can close if you try
to remove the glass panels before
you remove the oven door.
CAUTION!