Dmx-Controlled Operation; Addressing; Dmx-Protocol; Control Channels - EuroLite LED LMCTC Bedienungsanleitung

DMX-controlled operation

You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED LMCTC Controller will respond to the DMX-controller.
To set starting address, press the MODE button until the display indicates "System Mode". Press the SET
UP button and choose "DMX Addressing". Use the UP or DOWN button to set the desired starting address.
Controlling:
After having addressed the LED LMCTC Controller, you may now start operating it via your DMX-controller.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control Channels

Channel 1
Value:
0-11
12-23
24-35
36-47
48-59
60-71
72-83
84-95
96-107
108-119 Slow flow 1
120-131 Slow flow 2
Channel 2: Speed
0-255
Channel 3: Flash
0-255
Downloaded from www.Manualslib.com
Option
Blackout
Red
Green
Yellow
Blue
Purple
Cyan
White
Colour change
Step Time Value of 1/min up to 100/sec
Flash varies from OFF to 20Hz
manuals search engine
Value: Option
132-143 Roll chase 1
144-155 Roll chase 2
156-167 Multi colour
168-179 Fast flow 1
180-191 Fast flow 2
192-203 2 colour chase
204-215 2 colour flow
216-227 Colour fade
228-255 Auto run
20/22 5192861A_V_2_0.DOC