Dmx-Controlled Operation; Addressing; Dmx-Protocol; Control Channels - EuroLite LED LMCTC RBG Bedienungsanleitung

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED LMCTC RBG Bar will respond to the controller.
For address setting, press the MODE button until the display shows "A001".
Controlling:
After having addressed the LED LMCTC RBG DMX Lighting Controller, you may now start operating it via
your lighting controller.
Note:
After switching on, the LED LMCTC RBG DMX Lighting Controller will automatically detect whether DMX 512
data is received or not. If the data is received, the control LED flashes. If there is no data received at the
DMX-input, the control LED lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the LED WMS
8-fold set RBG.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control Channels

Channel 1
Value: Option
0-11 Blackout
12-23 Red
24-35 Green
36-47 Yellow
48-59 Blue
60-71 Purple
72-83 Cyan
84-95 White
96-107 Colour change
108-119 Slow flow 1
120-131 Slow flow 2
Channel 2: Speed
0-255 Step Time Value of 1/min up to 100/sec
Channel 3: Flash
0-255 Flash varies from OFF to 20Hz
Value: Option
132-143 Roll chase 1
144-155 Roll chase 2
156-167 Multi colour
168-179 Fast flow 1
180-191 Fast flow 2
192-203 2 colour chase
204-215 2 colour flow
216-227 Colour fade
228-255 Auto run
21/23 5192861A_V_1_1.DOC