F) Switching Dcf Reception On/Off; G) Switching Between Hour/Date Display; Setting The Time Zone - Conrad TE 857 Bedienungsanleitung

f) Switching On/Off DCF Reception
As already described in Chapter 9, the DCF reception can be switched on/off. Switching off the DCF reception may
be required, e.g. when there is a bad reception (basement rooms). Also see chapter 9. e).
• Once the batteries have been inserted, the DCF reception for the second receiver unit is automatically switched
on.
• Switch the DCF reception off by pressing the "" button (19) on the back of the second receiver unit until the DCF
reception icon to the left next to the clock display disappears (press button for about two seconds).
• Press the "" button again for about 2 seconds to switch the DCF reception back on. The DCF reception icon in
the display flashes. This means that the second receiver unit is carrying out a signal search for the DCF signal. Do
not move the second receiver unit during that time.
The reception attempt can take 3-10 minutes.
• Of course you can also set the time and date of the second receiver unit manually if you don't get any DCF radio
reception.

For this, see chapter 13. m).
g) Switching between Time/Date Display
By pressing the "MODE" button (20) briefly, you can switch between different display formats in succession:
• Hour/minute/second
• Hour/minute/day of week
• Hour/minute/day of week of set time zone ("ZONE" left besides the display)
• Hour/minute/second of set time zone ("ZONE" left besides the display)
• Date
h) Setting the Time Zone
You can set a time offset for the various time zones. This is subtracted or added to the DCF time.
• Press the "MODE" button (20) repeatedly until "ZONE" appears in the display next to the time.
• Press the "MODE" button (20) (approx. 2 seconds) until "0:00+" flashes.
• With the "" (17) and "" (19) buttons, the time offset to DCF time can now be set.
• Briefly press the "MODE" button (20) to save the setting.
99