Mounting To The Camera Recorder - Panasonic AG-CA300 Bedienungsanleitung

Mounting to the Camera Recorder

Mount the unit to a camera recorder using the following procedure:
<Notes>
When connecting this unit to the camera recorder, set the GENLOCK in the GENLOCK menu of the
camera recorder to "EXT". However, it is not necessary to set this with the AG-HPX300/301/302/304
and the AG-HPX500/502.
It may be required to update the version of the software for the camera recorder depending on the
version used by the camera recorder. Consult the dealer.
1
Align the guides at the back of the camera
recorder with the guides of the unit, and push
it in the direction of the arrow securely.
2
Connect the GENLOCK OUT connector of
this unit with the GENLOCK IN connector of
the camera recorder using a BNC cable
(commercially available) of 50 cm or shorter.
3
Mount the supplied ferrite core on the BNC
cable within 15 cm from the SDI connector of
the camera recorder.
Connect the SDI IN connector of this unit with
the SDI OUT connector of the camera
recorder* using a BNC cable (commercially
available; 3C-FW) of 50 cm or shorter. There
are camera recorders that display VIDEO
OUT, but make sure to set it to SDI signal by
the menu settings or switch settings before
connecting.
* If the output connector of the camera
recorder is set to SDI, any connector can
be used.
4
Connect one end of the power cable
connected to the base station to the DC IN
24 V connector of the unit.
5
Connect the REMOTE connector of the unit
with the REMOTE connector of the camera
recorder using the included REMOTE cable.
5
3
2
E-14
4