Setting Up The Camera Recorder - Panasonic AG-CA300 Bedienungsanleitung

Precautions When Connecting the System
Make sure to connect the GENLOCK OUT
connector of this unit and the GENLOCK IN
connector of the camera recorder using a BNC
cable, and set the GENLOCK menu of the
camera recorder to "EXT".*
(However, this setting will be automatically
performed on the AG-HPX300/301/302/304
and the AG-HPX500/502, so it is not required
to perform this setting)
Also, if the camera recorder is being used in
HD mode, set the "GL PHASE" in the
GENLOCK menu to "HD SDI".*
Connect the cables as shown in 1 - 6 on page
7.
* For the setting method, refer to the operating
instructions of the camera recorder.

Setting up the camera recorder

Setup the camera recorder to configure a system by connecting this unit with the AG-BS300P/E and the
camera recorder.
For the setting of the camera recorder, refer to the operating instructions of the camera recorder.
Setting of the video format
Using camera recorder menu operations or switch
operations, set the video signal format of the
output from the SDI output connector of the
camera recorder and the video signal format for
recording to the same format.
Setting of the GENLOCK MODE
Set the GENLOCK MODE of the camera recorder
to GENLOCK: EXT using the menu operation of
the camera recorder.
(This setting is not necessary for AG-HPX300/
301/302/304 and AG-HPX500/502.)
Setting of the GENLOCK PHASE
Set the GL PHASE of the camera recorder to GL
PHASE: HD SDI using the menu operation of the
camera recorder.
If it is used connected to the AG-HPX500/502, set
the GL SELECT item to SDI, and the GL PHASE
item to OFF.
E-9
(continued)
Do not perform version update of the camera
recorder while this unit and the camera adapter
are connected. Perform the version update of
the camera recorder with the camera recorder
on its own.
When connecting this unit with the camera
recorder, match the system format of the
camera recorder with the video format of the
SDI signal.
In systems combining this unit and the
AG-HPX500/502, the AG-HPX500/502 should
not be used in playback mode or IEEE1394
mode.
When connecting this unit with the
AJ-HDX900P/E, set the OUTPUT SEL switch
on the camera recorder so the HD SDI signal is
output from the VIDEO OUT connector of the
camera recorder.
Setting of the CRT VF
Set the VF TYPE to be used on the camera
recorder using the menu operation of the camera
recorder.
If it is set to VF TYPE: SD, only the SD video can
be checked for the return video (RET video) from
this unit.
Setting of the battery
Power is supplied from the base station to the
camera recorder from the battery connector of the
camera recorder via this unit. When the power is
supplied from the base station connecting this unit
and the camera recorder, set the battery setting of
the camera recorder to "TYPE B", the voltage to
display as FULL to "13.0 V", near-end voltage to
"12.5 V", and end voltage to "12.0 V" when the
power is supplied to the camera recorder. For
details, refer to the operating instructions of the
camera recorder.