Herunterladen Inhalt Inhalt Diese Seite drucken

Accessories; Softener - Wega POLARIS 1GR Bedienungs- Und Wartungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 101
Polaris
15

Accessories

15.1 Softener

Mains water contains insoluble salts, which cause
the build-up of lime scale deposits in the boiler and
in other parts of the machine. The softener makes
it possible to eliminate or substantially reduce the
presence of these mineral salts. The resin softener
has the property of retaining the calcium contained
in the water. For this reason, the resins become
saturated after a certain period and must be re-
generated with coarse kitchen salt (NaCl, sodium
chloride) or special water softening salt. It is very
important to regenerate the softener within the
established times. The regeneration is to be done
regularly every 15 days. However, in locations with
very hard water, it will be necessary to regenerate
more frequently. The same rule can be applied to
places where there is a large consumption of hot
water for tea or other uses.
Softener regeneration
Proceed as follows:
move levers (B) and (E) from left to right;
remove the lid by loosening the knob (A);
release enough water through the pipe (C) to
make room for the salt to be added, based on
the model (see the table on the following page);
clean any salt or resin residue from the gasket
located on the lid;
put the cover back in place by screwing the knob
(A) down securely and move the lever (B) back
from right to left;
let the salt water drain from the little hose (D)
until the water is no longer salty (about 30-60
minutes). The salt allows the accumulated min-
eral salts to be released;
switch the lever (E) from right to left back to its
initial position.
A
B
E
58
C
D
The build-up of lime scale deposits in the hydraulic
circuit and boiler inhibits thermal exchange, thus
compromising proper operation of the machine.
i
Heavy incrustations in the boiler may cause long
machine shutdowns and in any case invalidate any
guarantee, because this symptom indicates that
regeneration has been neglected.
In order to keep the softener and hence the ma-
chine in perfect operating condition, it is necessary
to perform regeneration periodically based on the
use of the softener and the hardness of the water
that is used. The table below shows the quantity of
softened water based on the hardness of the water
in the various units of measure:
°f French degree
°d: German degree = 1.8 °f
mg CaCO
3
For further information on installation, start-up
and regeneration of the softener, refer to the relative
instruction manual.
Amount of softened water based on hardness
°f
30
40
°d
16,5
22
mg CaCO
30
40
3
8 liters
1000 lt 900 lt
12 liters
1500 lt 1350 lt 1050 lt 750 lt
16 liters
2100 lt 1800 lt 1400 lt 1000 lt 2.0 kg
Softener model
8 litres
12 litres
16 litres
60
80
33
44
salt
60
80
700 lt
500 lt
1.0 kg
1.5 kg
Amount of salt
1.0 kg
1.5 kg
2.0 kg
User manual

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Polaris compPolaris 2grPolaris 3gr

Inhaltsverzeichnis