Getting Started; Boiling Water - Silvercrest SWKE 2400 A1 Bedienungsanleitung Und Sicherheitshinweise

7. Getting started

Before preparing water for consumption for the first time, you must first clean the kettle (4) to
remove dust and any residues from the packaging materials. Proceed as follows:
1. Open the lid (10) by pressing the lid release button (9) and rinse the kettle (4) with clean
water.
2. Fill the kettle (4) with drinking water up to the "1.7l MAX" mark.
3. Close the lid (10) by pressing down until it clicks into place and allow the water to boil once
(see next step "Boiling water") then pour it away.
Repeat steps 1 to 3 once more. The kettle (4) is then clean and disinfected. The kettle (4) is now
ready for use.

7.1. Boiling water

DANGER: Risk of electric shock
Keep the base (5) away from water. Otherwise there is a risk of lethal electric
shock.
WARNING
On the very first use, boil and pour away water twice (see previous section
"Getting started").
WARNING
Always use fresh drinking water. Discard any water left to stand in the
kettle (4) for longer than one hour.
Cord wrap
There is an integrated cord wrap on the
underside of the base (5). This enables
you to adjust the power cord (7) length to
suit your conditions.
When the kettle is not in use you can
reduce the cord length to a minimum here.

Unwind the power cord (7) underneath the base (5).

Place the base (5) on an even, non-slip and dry surface. Note that the power cord (7) must be
fed through one of the notches provided on the underside of the base (5) to ensure stable
positioning.
SilverCrest SWKE 2400 A1
English - 29