Silvercrest SHTD 2200 E1 Bedienungs- Und Sicherheitshinweise Seite 26

Protect the power cord against
damages . Do not let it hang over
sharp edges, do not squeeze or
bend it . Keep the power cord
away from hot surfaces and open
flames .
For additional protection, the
installation of a residual current
device (RCD) having a rated
residual operating current not
exceeding 30 mA is advisable in
the electrical circuit supplying the
bathroom . Ask your installer for
advice .
The use of extension cords is not
recommended . If the use of an
extension cord is necessary, it
must be designed for a current
flow of at least 10 A . Lay cords
in such a way that they may not
be tripped over or otherwise
damaged .
Operation
m WARNING: Do not use this
product near bathtubs, showers,
basins or other vessels containing
water .
The product must not be left
unattended while it is connected
to the supply mains .
Do not operate the product with
wet hands or while standing on a
wet floor . Do not touch the power
plug with wet hands .
Do not pull the power plug out of
the electrical outlet by the power
cord . Do not wrap the power cord
around the product .
Protect the product, its power
cord and power plug against
dust, direct sunlight, dripping and
splashing water .
Switch off the product before
–changing attachments,
–cleaning,
–disconnecting the product from
the power supply .
When the product is used in a
bathroom, unplug it after use since
the proximity of water presents a
hazard even when the product is
switched off .
GB/MT 25