Installation And Connection - Oase OptiMax 2000 Gebrauchsanleitung Und Garantie

- EN -

INSTALLATION AND CONNECTION

N O T E
Ensure that the pump never runs dry!
Possible consequences: The pump will be destroyed.
Protective measure: Regularly check the water level
in the aquarium.
 A
• Fit the supplied suction cups with a twisting
movement.
– The suction cups adhere to clean, smooth
surfaces.
Submerged installation of the pump
 B, C
• Fit the hose connector as required and connect to
a suitable hose. (→ Technical data)
• Adjust the flow at the flow regulator.
– To reduce the flow: Move the flow regulator in
the direction -.
– To increase the flow: Move the flow regulator
in the direction +.
• Install the device in the aquarium.
16
Install the unit at a dry place
N O T E
The pump is not self-priming and must be installed
below the level of the water.
How to proceed:
 D
• Pull off the filter housing.
• Fit the hose connector as required and connect to
a suitable hose. (→ Technical data)
• Adjust the flow at the flow regulator.
– To reduce the flow: Move the flow regulator in
the direction -.
– To increase the flow: Move the flow regulator
in the direction +.
• Install the device outside of the aquarium.
Opti