Connecting The Electrical Power To The Generator - Dometic TEC29 Montageanleitung

TEC29, TEC29LPG
10 Connecting the electrical power to the
generator
D
DANGER! Danger of electrocution
Make sure there is no voltage at electrically operated components
before carrying out work on them!
I
NOTE
Observe the applicable guidelines in the country of the consumer.
10.1 Important notes on the electrical connection
 Only a qualified electrician should connect the generator to the electrical
power.
 Check that the voltage specification on the type plate is the same as that
of the power supply.
 Do not lay the 230 Vw mains cable and the 12 Vg cable together in the
same cable duct.
 Do not lay cables which are loose or bent next to electrically conductive
material (metal).
 Connect the generator to a power circuit which can supply the necessary
current (see chapter "Technical data" on page 30).
 Select the cross-section of the cable as follows:
– 230 V: 2.5 mm²
– 12 V battery charger: 2.5 mm²
– Battery connection (length < 6 m): 10 mm²
– Battery connection (length > 6 m): 16 mm²
 Install a manual main switch which can disconnect all the consumers from
the generator with the exception of the battery.
EN

Connecting the electrical power to the generator

23