P.Lindberg 9060983 Original Bedienungsanleitung Seite 95

Attaching the handlebar:
WARNING – Failure to correctly adjust and tighten the bolts that hold the handlebar
can lead to a serious accident.
Inflating the tyres:
NB: Exercise caution. It is very important to keep the tyres in good condition and use
the correct type and size when replacing the tyres, as an incorrect tyre can lead to a
safety hazard.
Regularly check the tyres for wear and replace as required.
P. Lindberg A/S
Tel.: +45 70212626
NB: The rear wheels are supplied already inflated, but it cannot
be avoided that they may have lost some air over time.
Therefore always ensure to pump the tyres to the
recommended tyre pressure before use.
Use a bicycle pump with a manometer and pump the tyres to
the tyre pressure that is stated on the tyres.
Sdr. Ringvej 1
6600 Vejen, Denmark
A. Bolt M8 x 50 (qty. 4)
B. Top light
C. Bottom light
D. Cover
E. Handlebar
1. Set the bottom clamp (C) on the
handlebar's assembly plate and place
the handlebar (E) in the bottom clamp.
Next, fit the top light (B) on the
handlebar using qty. 4 bolts (A).
2. Fit the steering in an upright and
vertical position and tighten all of the
bolts securely using a fork spanner.
3. Fit the cover to the handlebar.
14
MAN 9060983 EN V1
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk