PRODUCT MAINTENANCE
The jumper is in the terminal strip – D
Lift up the fuse cover – C
Remove the jumper from the terminal strip – B
Close the fuse cover – A
Reinstall the cover on the electrical panel.
Insert the compressor into the box.
Connect the cabinet to the compressor by inserting the power cord with connector (1) into a
power socket (2). (Fig. 12)
Connect the device to the electrical mains
Activate the compressor by turning on the switch on the pressure switch and the switch (4) on
the cabinet (Fig. 13).
Compressor with cabinet - when operating in the cabinet, there must not be an electrical connection.
(Fig. 19, Fig. 20 pos. A).
Note : In case of using a compressor without a cabinet or in case of maintenance, a jumper
which is not installed into the terminal strip should be kept in a designated place next to the
electrical panel.
17.12. Cleaning of the exterior surfaces of the product
Use neutral agents for cleaning of the external surfaces of the product.
The use of aggressive cleaning agents and comprising alcohol and chlorides
may lead to the damage of the surface and the discoloration of the product.
18. LONG-TERM SHUTDOWN
If the compressor is not going to be used for long period, it is recommended to drain all condensate
from the air tank and switch on the compressor for about 10 minutes, keeping the drain valve open
(1) (Fig. 14). Thereafter switch off the compressor using the switch (2) on the pressure switch (1)
(Fig. 13), close the drain valve and disconnect the device from the mains.
19. DISPOSAL OF DEVICE
Disconnect the device from the mains.
Release air pressure in the pressure tank by opening the drain valve (1) (Fig. 14).
Dispose of the device according to the applicable local rules.
Order a specialized organization to sort and dispose of waste.
Product components after its operational lifetime have no negative environmental effect.
03/2020
53
NP-DK50 2V 50, 2x2V 110-A-4_03-2020-MD