Repair; Returning The Device; Cleaning; Disposal - Stahl 8013/3 Serie Betriebsanleitung

Cleaning

EN
9.3

Repair

EN
EN
EN
EN
EN
EN
9.4

Returning the Device

EN
• Only return or package the devices after consulting R. STAHL! Contact the responsible
EN
representative at R. STAHL for this.
EN
EN
R. STAHL's customer service is available to handle returns if repair or service is required.
EN
EN
EN
EN
EN
• Contact customer service personally.
EN
or
EN
EN
• Go to the www.stahl.com website.
• Select "Downloads" > Customer service > "RMA Request".
EN
• Fill out the form.
EN
Wait for confirmation. R. STAHL's customer service will contact you. You will receive
EN
an RMA slip after speaking with customer service.
• Send the device along with the RMA slip in the packaging to
EN
R. STAHL Schaltgeräte GmbH (refer to Section 1.1 for the address).
EN
EN
10 Cleaning
• Clean the device only with a cloth, brush, vacuum cleaner or similar items.
• When cleaning with a damp cloth, use water or mild, non-abrasive, non-scratching
cleaning agents.
• Do not use aggressive detergents or solvents.
11

Disposal

• Observe national and local regulations and statutory regulation regarding disposal.
• Separate materials when sending it for recycling.
• Ensure environmentally friendly disposal of all components according to the statutory
regulations.
16
LED Indicating Lamps for Panel Mounting
Series 8013/3
Explosion hazard due to improper repair!
Non-compliance results in severe or fatal injuries.
• Repair work on the devices must be performed only by
R. STAHL Schaltgeräte GmbH.
Only return or package the devices after contacting and consulting R. STAHL!
DANGER
129221 / 8013603300
2016-09-27·BA00·III·en·03