Safety Notes; Operating Instructions Storage; Personnel Qualification; Safe Use - Stahl 8013/3 Serie Betriebsanleitung

3

Safety Notes

3.1

Operating Instructions Storage

• Read the operating instructions carefully.
• Store the operating instructions at the mounting location of the device.
• Observe applicable documents and operating instructions of the devices to be
connected.
3.2

Personnel Qualification

Qualified specialist personnel are required to perform the tasks described in these
operating instructions. This primarily applies to work in the following areas:
• Project engineering
• Mounting/dismounting the device
• (Electrical) installation
• Commissioning
• Maintenance, repair, cleaning
Specialists who perform these tasks must have a level of knowledge that meets
applicable national standards and regulations.
Additional knowledge is required for tasks in hazardous areas! R. STAHL recommends
having a level of knowledge equal to that described in the following standards:
• IEC/EN 60079-14 (Electrical installations design, selection and erection)
• IEC/EN 60079-17 (Inspection and maintenance of electrical installations)
• IEC/EN 60079-19 (Equipment repair, overhaul and reclamation)
3.3

Safe Use

Before mounting
• Read and observe the safety notes in these operating instructions!
• Ensure that the contents of these operating instructions are fully understood by the
personnel in charge.
• Always consult with R. STAHL Schaltgeräte GmbH if using the device under operating
conditions which are not covered by the technical data.
• We cannot be held liable for damage at the device caused by incorrect or unauthorised
use or non-compliance with these operating instructions.
For assembly and installation
• Have mounting and installation performed only by qualified and authorised persons
(see "Qualification of the personnel" section).
• During installation and operation, observe the information (characteristic values and
rated operating conditions) on the type plates and data plates and information signs
located on the device.
• Before installation, make sure that the device is not damaged.
• When using type 8013/3.1 and type 8003/1.3, the reverse side of the device must be
protected from mechanical damage.
129221 / 8013603300
2016-09-27·BA00·III·en·03
LED Indicating Lamps for Panel Mounting
Series 8013/3
Safety Notes
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
5