The All On/All Off Feature; Troubleshooting; Device Does Not Respond To The Remote Control Commands; Some Buttons Do Not Work Properly - Silvercrest SFB 10.1 C3 Bedienungsanleitung

SilverCrest SFB 10.1 C3

The All on/All off feature

If you have programmed your remote control to control several devices,
this feature lets you switch all of them on or off at the same time by just
pressing one button. To do so, press and hold the
a few seconds. This switches all the devices on or off at the same time.
Depending on the number of devices programmed, this can take up to 10
seconds. The following is required for this feature to work:

A clear line of sight between the remote control and each device
you want to switch on/off.

All devices need to support powering on/off via remote control.

The automatic code search, brand code search and macro
functions must be disabled.

Troubleshooting

Device does not respond to the remote control commands


Please check that you have selected the correct device with the
remote control.

Point the remote control directly at the device.

Check if the remote control has been programmed with the correct
code for your device.

It is possible that the device is not compatible with programming
using the code list. In this case, please program the remote control
by using the learn function.

The batteries are low or empty. Replace the batteries with new
batteries of the same type. See also the chapter "Inserting the
batteries".

Some buttons do not work properly


It is possible that not all functions of your original remote control
are supported.

The code entered does not support all the functions of your device.
Try to find a code that matches your device better.

Program any buttons that do not work properly using the learn
function.

Before programming a device button using brand code search or
automatic search, please carry out a RESET for this button first. If
this device had previously been programmed using the learn
function, any learned keys would not be overwritten by the new
programming.

The LCD display does not work


The batteries are low or empty. Replace the batteries with new
batteries of the same type. See also the chapter "Inserting the
batteries".

TOP Text buttons not working in Teletext mode


While
recording/playback control buttons (5) are used to control the
selected tape or disc player. In this case, these buttons cannot be
used for the TV TOP Text functions.
110 - English
the "PLAYBACK" function is
button (3) for
enabled, the