Preparatory Work; Switching The Appliance On/Off - Dirt Devil CAVALIER DD698-2 Bedienungsanleitung

17

Preparatory work

Unpacking and assembling
Check that the contents are complete (Fig. 1 ,
Fig. 2 for optional accessories). If you notice any
transport damage or if anything is missing, contact
your dealer immediately.
(Fig. 1 /1) to the suction tube (Fig. 1 /2, Fig. 3 ) and
the lower connection piece of the suction tube by
inserting it into the stop catch on the floor nozzle
(Fig. 4 ) so that you hear and feel it click into place.
NOTE:
If you wish to detach the floor nozzle or the suc-
tion tube later, press in the release catch to dis-
engage the components from each other. Then,
pull the components apart.
NOTE:
Place the appliance in a corner of the wall, place
it flat on the floor or insert the appliance into the
wall mount (Fig. 8 ) so that it does not topple
over.
Charging the rechargeable battery
!
WARNING!
Risk of fire or explosion! Only use the mains
adapter included in the scope of supply to
charge the rechargeable battery.
Connect the mains adapter cable to the charging
socket on the appliance (Fig. 5 ).
mains adapter to a socket (Fig. 6 ).
LED lights up constantly in red to indicate the charg-
ing process (Fig. 7 ). After a maximum of
5.5 hours, the "ON/OFF" LED switches to green.
The rechargeable battery is then charged.
Disconnect the mains adapter from the socket (to
save electricity) and disconnect the mains adapter
cable from the appliance.
Installing the wall mount
Connect the handle of the appliance to the wall
mount (Fig. 8 ). Place the appliance against the
wall, together with the wall mount, so that the floor
nozzle rests flat on the floor.
the drilled holes with a pencil.
Drill the holes. Remove the wall mount from the
handle and screw it to the wall with suitable fasten-
ing accessories. Insert the hole covers.
Connect the appliance
Connect the
The "ON/OFF"
Mark the positions for
EN

Switching the appliance on/off

NOTE:
When the"ON/OF" LED (Fig. 7 ) flashes red, the
rechargeable battery charge is low and the ap-
pliance will switch off within 20 seconds. Fully
charge the rechargeable battery to use the appli-
ance again > „Charging the rechargeable battery"
on page 17.
To switch on the appliance, press and hold the
ON/OFF button on the handle (Fig. 9 /1).
The motor starts. "ON/OFF" LED lights up
green.
NOTE:
You can lock the ON/OFF button so that the
appliance remains switched on permanently
(Fig. 9 /2). Do not forget to release the locking
mechanism after cleaning.
To switch off the appliance, release the ON/OFF
button (Fig. 9 /1).
The appliance switches off. The "ON/OFF" LED
goes out.
Vacuum-cleaning floors or furniture
Fit one of the following nozzles as required if
included in the scope of supply:
NOTE:
The nozzles can also be attached directly to the
connection port on the base appliance.
(Fig. 10+19 ).
• Combo floor nozzle with rotating brush for option-
al activation for hard floors and carpets (Fig. 1 /3)
CAUTION!
Make sure that the surface can withstand the
rotating brush without becoming damaged.
• Parquet brush (gentle on floors) (Fig. 2/D )
• 3-in-1 combo nozzle (brush for joints, furniture &
upholstery) (Fig. 1/4 )
• Long flexible crevice nozzle (Fig. 2/A )
• Extended flexible furniture brush (Fig. 2/B )
Switch on the appliance.
or the piece of furniture.
rotating brush roller on the combo floor nozzle as re-
quired using the button on the top of the appliance
(Fig. 7 /1). Switch off the appliance.
Vacuum-clean the floor
Activate or deactivate the