Control Panel; Before First Use - Electrolux GT380 Benutzerinformation

58 www.electrolux.com

5. CONTROL PANEL

5.1 Control panel
1
Temperature indicator
1
SUPER indicator
2
SET button
3
OFF button
4
Running indicator
5
5.2 Switching ON/OFF
1. To switch on the appliance insert the
plug into the mains socket.
2. If the indicators are off, press the
OFF button for 3 seconds.
3. To switch off the appliance, press the
OFF button for 3 seconds.
5.3 Temperature regulation
To set the temperature:

6. BEFORE FIRST USE

WARNING!
Refer to Safety chapters.
6.1 Cleaning the interior
Before using the appliance for the first
time, the interior and all internal
accessories should be washed with
lukewarm water and some neutral soap
to remove the typical smell of a brand-
new product, then dried thoroughly.
2
5 4
1. Press SET button repeatedly until
you reach the desired temperature.
MAX setting is the coldest one.
2. The temperature sets 5 seconds after
the last press.
3
The exact setting should be chosen
keeping in mind that the temperature
inside the appliance depends on:
• room temperature
• how often the lid is opened
• the quantity of food stored
• the location of the appliance.
5.4 SUPER function
The SUPER function accelerates the
freezing of fresh food and, at the same
time, protects already stored foodstuffs
from undesired warming.
To activate the function:
1. Press SET button repeatedly until the
SUPER indicator lights up.
2. The function sets 5 seconds after the
last press.
The SUPER function stops automatically
after 52 hours and the temperature goes
back to the previous setting.
You can stop the function manually
before that time, by pressing the SET
button and setting the desired
temperature.
5.5 Running indicator
This indicator is on when the compressor
operates and it turns off when the
compressor stops working.
6.2 Electrical Connection
When you connect the appliance to the
power supply, or it turns on after a power
failure all indicator lights flash once.
CAUTION!
Do not use detergents,
abrasive powders, chlorine
or oil-based cleaners as they
will damage the finish.