Installation; Connecting The Product - LIVARNO LUX IAN 288476 Montage-, Bedienungs- Und Sicherheitshinweise

The included ground stake
or flower bed). The soil must be soft enough to push the ground stake
in without applying force (e.g. hammer strike), but must be firm enough
at the same time to ensure the product is securely fixed.

Installation

When selecting the mounting location, pay attention to the following:
Make sure that the spotlight
move the spotlight vertically.
Make sure the motion detector
detector has a maximum coverage range of 10 m, with a coverage
angle of about 180 ° (depending on the mounting height – a height
of 1.80–2.50 m is ideal).
Make sure the motion detector
lighting. This can influence its functioning.

Connecting the product

Open the connection box
loosen the fixing screws
Run the flexible cord, type H05RN-F 3G 1.0 mm
gland and into the connection box
13
cord should not exceed 2.5 m. Open the terminal block
slot head screw driver to loosen the fixing screws.
Attach ferrules and cord anchorage
them with the terminal block
to the markings on the terminal block
for the earth wire) (Fig. E). Close the terminal block
is suitable for mounting in soil (e.g. lawn
10
illuminates the desired area. You can
4
covers the desired area. The motion
9
is not illuminated at night by street
9
by using a crosshead screw driver to
6
of the connection box
12
6
to the wires of the cord. Connect
14
in the connection box
15
15
(Fig. B).
6
, through the cable
2
. The length for the flexible
15
. Pay attention
6
(L for live, N for neutral and
15
by using a
again by
GB 11