Cleaning; Troubleshooting - Bosch ErgoMixx serie Gebrauchsanleitung

en

Cleaning

■ Place the lid on the bowl and turn all the
way anticlockwise.
■ Place the base unit on the attachment
and lock into position.
■ Insert the mains plug.
■ Set required speed using the speed
control.
■ Hold the base unit and multifunction
accessory firmly and switch the
appliance on.
■ Add the ingredients for slicing or
shredding through the filling opening.
■ When pushing down ingredients for
slicing or shredding, only apply light
pressure to the pusher.
Warning!
Empty the bowl before it becomes so full
that the ingredients for slicing or shredding
reach the carrier disc.
■ Release the On button after processing.
After using the appliance:
■ Disconnect the mains plug.
■ Press the release buttons and remove
the base unit from the attachment.
■ Turn lid clockwise and remove from the
bowl.
■ Grip the carrier disc by the recessed
grips and lift out of the bowl.
■ Turn the carrier disc over and carefully
press out the insert from the underside
(Fig. F).
Cleaning
The appliance and the tools used must be
thoroughly cleaned after each use.
W Risk of electric shock!
Disconnect the mains plug before
cleaning it.
Never immerse the base unit in liquids and
do not clean in the dishwasher.
Do not steam-clean the appliance!
Warning!
Surfaces may be damaged. Do not use
abrasive cleaning agents.
Tip: When processing foods such as red
cabbage and carrots, plastic parts may
become discoloured. This can however be
removed with a few drops of cooking oil.
16
■ Disconnect the mains plug.
■ Wipe the base unit with a damp cloth
and then rub dry.
■ The blender jug can be cleaned in the
dishwasher.
■ Clean the blender foot in the dishwasher
or with a brush under running water.
■ Dry the blender foot in an upright
position (blender blade face up) so that
any trapped water can run out.
Whisk
Warning!
Never immerse the gear attachment in
liquids and do not clean under running
water or in the dishwasher.
■ The whisk can be cleaned in the
dishwasher.
■ Wipe the gear attachment with a damp
cloth only.
Multifunction accessory
Warning!
Never immerse the lid of the multifunction
accessory in liquids and do not clean in the
dishwasher.
■ Wipe the lid with a damp cloth only or
rinse briefly under running water.
■ The bowl, universal blade, carrier discs
and disc inserts are dishwasher-safe.
■ Do not wedge plastic parts in the
dishwasher as they could become
deformed.

Troubleshooting

Fault
Appliance switches off during use.
Solution
The overload protection device is activated.
■ Switch off the appliance and disconnect
the mains plug.
■ Leave the appliance to cool down
for approx. 1 hour to deactivate the
overload protection device.
■ Switch the appliance on again.
If the fault cannot be eliminated, please
contact customer service.