Ryobi RLT-5030AH Bedienungsanleitung Seite 21

RLT-5030AH_25 lgs
GB
F D E I
Problem
Line will not advance when
tap bump button.
Bump head is hard to turn.
Grass wraps around the
attachment shaft and the
trimmer head assembly.
Waste electrical products should not be disposed of together with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for recycling advice.
13/01/06 15:42 Page 15
P NL S DK N FIN GR HU
English
TROUBLESHOOTING
Possible cause
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up
around head.
Cutting tall grass
at ground level.
DISPOSAL
CZ RU RO PL SLO HR TR EST LT
Solution
1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing the Cutting
Line" earlier in this manual).
3. Pull lines while alternately pressing down on and
releasing bump button.
4. Remove line from spool and rewind (Refer to
"Replacing the Cutting Line" earlier in this manual).
Clean affected parts of the machine.
Cut tall grass from the top down.
15
LV SK BG