Maintenance And Cleaning; Technical Characteristics - Mestra R-080010 Bedienungsanleitung

The R-080010 / R-080020 / R-080025 is a
practical electro-vibrator unit specially designed for
compacting materials for the jewellery and dental
mechanics sectors. To obtain best performance
from the unit, we recommend you read the
following instructions carefully.
• Place the unit on a smooth, firm, perfectly
horizontal surface. The electro-vibrator is fitted
with rubber suction caps (A) to ensure firm
attachment.
• Connect the plug to a 220 V, 50/60 Hz earthed
power outlet.
• Place the cylinder or items to be vibrated on the
unit's vibration
impression bowls, the mixture can also be
compacted by resting the bowl firmly on the
edge of the unit and holding down the bowl
handle with your hand.
• Adjust the vibration regulator (B) to its minimum
setting (turn the knob anti-clockwise), then
connect the On switch (D) and the electro-
vibrator will start up.
• Slowly move the unit's regulator (B) clockwise
and check that the oscillation rate gradually
increases. Set the regulator to a suitable
amplitude for the operation.
• After a short time, once the mixture is properly
compacted, switch the unit off using the On/Off
switch (D).

TECHNICAL CHARACTERISTICS

Voltage:
Dimensions:
Consumption:
Weight:
Vibrations per minute:
platform. In the case
R-080010
230 V, 50/60 Hz
270 x 380 x 140 mm
260 W
13.2 kg
3000
GB

MAINTENANCE AND CLEANING

To ensure a long, trouble-free service life and
performance of the unit, we recommend as follows:
• After using the unit, always clean away any
splashes of mixture before they dry.
• Clean the vibration platform and outer housing
of the electro-vibrator regularly with a damp
cloth. The rubber cover protecting the platform
can be easily removed to facilitate cleaning.
• As a precaution, always disconnect the unit from
the mains before cleaning it.
• To remove the vibration platform (C), remove
the 4 bolts next to the suction pads (A) on the
base of the unit (see photograph, page 2).
PRECAUTIONS
of
♦ Before connecting the unit ensure that the power
supply is 220 V, 50/60 Hz and earthed.
♦ Do not use the unit in wet places or close to heat
sources.
♦ Do not place easily broken containers or other
objects on the vibration platform.
♦ Do not allow children or unskilled personnel to
handle the unit.
♦ Do not pull, twist or bend the mains cable
excessively.
♦ Before cleaning the unit, ensure that it is
unplugged.
♦ Never immerse the unit in liquid when cleaning
it.
♦ Do not place hot containers or objects on the
vibration platform, as this may damage the
rubber.
R-080020
230 V, 50/60 Hz
220 x 220 x 105 mm
240 W
6.3 kg
3000
R-080025
230 V, 50/60 Hz
220 x 160 x 105 mm
240 W
6.3 kg
3000
English
5