Charging The Battery - MPM MOD-35 Bedienungsanleitung

CHARGING THE BATTERY

CAUTION! Charge the battery before the first use. Charging the battery takes about 3.5-4.5 hours.
CAUTION! Use only the supplied charger for charging the battery. It is not possible to turn on the vacuum clean-
er while charging the battery.
1. Install the battery (15) in the motor module (1), do not turn the vacuum cleaner on.
2. Plug the charger cable (26) to the power adapter input (27) and plug the charger into the
power outlet – the battery charge indicator will start flashing (6a) – during the charging pro-
cess 1, 2 or 3 dots will be flashing.
3. Full battery charge is signalled by three continuously lit dots on the display (6a), and the
display will turn off afterwards.
4. Unplug the charger from the power outlet and the charger cable from the vacuum cleaner.
OPERATING THE VACUUM CLEANER
1. Make sure that the vacuum cleaner has been assembled properly and the battery is charged.
2. Attach appropriate tools:
- multi-purpose electric brush with lighting (20) – for all types of solid surfaces and carpets,
LED lighting illuminates the cleaned surface, ensuring perfect vacuuming
- slide-out multi-purpose tool (24) – intended for vacuuming of blinds, lampshades, mirrors
and all areas which require gentle cleaning, adjustable length of the brush makes it suitable
for different vacuuming conditions
- slot tool (22) – for vacuuming corners, spaces under furniture and other hard to reach
areas inaccessible to other accessories.
Depending on the needs, plug the tools to the suction wand (18) or the socket (17).
3. Turn on the vacuum cleaner with the switch (3). The vacuum cleaner with operate at low
suction power. After turning the vacuum cleaner on, the battery charge indicator also lights
up. (6a).
4. To activate high suction power press the maximum suction power button "MAX" (4). Press-
ing the button again deactivates the high suction power. The activated high suction power
is displayed by the indicator (6d).
5. While using the electric brush (20) set the mode dedicated for vacuuming floors or carpets.
Selection of a mode is done with the electric brush mode selection button (5). Selection of a
mode is signalled by a corresponding "CARPET" icon (6b) or "FLOOR" icon (6c).
6. Monitor the capacity of the dust canister (8). An overfilled canister reduces the vacuuming
efficiency, increases energy consumption and leads to quicker accumulation of dust on the
filters.
CAUTION! Do not allow the dust canister to become overfilled! The dust level in the canister cannot exceed the
"MAX" level.
CAUTION! If the suction power of the vacuum cleaner dropped significantly, it means that the wand and/or the
suction nozzle are clogged and/or the dust canister is full. Clear the wand and/or the suction nozzle and/or
empty the dust canister.
7. Should you require to empty the dust canister, proceed as follows:
- turn off the vacuum cleaner with the switch (3)
- place the dust canister over a waste bin
14