Exposure Priority; Audio - Sony SNC-EMX30 Handbuch

76 en | Configuration
3.
4.
5.
6.
Note:
To add an additional adjustment point to the area, double-click on a side.
Click Set to apply the changes.
4.3.12

Exposure priority

(Only applicable to SNC-HMX cameras)
Exposure priority is used to increase or decrease the priority of a specific area when
determining the overall exposure for the image. Eight regions can be defined.
1.
2.
3.
4.
5.
Click Set to apply the changes.
4.3.13

Audio

(Only available for cameras with audio functions)
You can set the gain of the audio signals to suit your specific requirements. The live video
image is shown in the window to help you check the audio source. Your changes are effective
immediately.
If you connect via Web browser, you must activate the audio transmission on the 'Live'
functions page. For other connections, the transmission depends on the audio settings of the
respective system.
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data is encoded according to the selected format and requires
additional bandwidth. If you do not want any audio data to be transmitted, select Off.
Audio
Enable or disable the audio recording option.
Audio input
(Only applicable to SNC-EMX30, EMX30R, EMX50, and EMX50R)
Select the audio input from the drop-down list.
Microphone volume
(Only applicable to SNC-EMX30, EMX30R, EMX50, and EMX50R)
Adjust the audio level with the slider(s). Adjust so that the indicator does not go into the red
zone.
Line Out
(Only applicable to SNC-EMX cameras)
Adjust the audio level with the slider(s). Adjust so that the indicator does not go into the red
zone.
2019-07 | V01 | DOC
Check the enabled box to activate the mask.
Use the mouse to move the mask; drag the corner points to resize.
Click Set.
To remove a mask, select it and click the waste bin icon.
Select the region you wish to define in the drop-down box.
Select Low, High or Off in the drop-down box for the region you have selected.
– Low reduces the priority
– High increases the priority
– Off uses normal priority
Use the mouse to define the area for each of the regions.
– Drag the corner points or sides,
– Double-click on a side to add one additional point to the polygon.
Click Set.
To remove a region, select it and click the waste bin icon.
User manual
Network camera
Sony Corporation