Eureka mythos Gebrauchanweisungen Seite 33

EN
6.4.3 DOSE SELECTION IN bArISTA MODE
During operation in "barista" mode, the display will appear as shown in the figure above;
the time for the dose will be shown in seconds on the left side at the bottom of the display,
while the relevant button will stay lit.
Using the and
dose will be automatically stored to memory when grinding is enabled using the contact
with the micro (6) or when another dose key is pressed. The new set dose will not be stored
to memory if the machine is switched off accidentally (in this case, the previous dose will
remain in the machine memory).
6.4.4 SELECTING CONTINUOUS MODE IN AUTOMATIC PrESELECT
Select the key for continued grinding
below. Insert the filter holder cup or other device to collect the ground coffee until the micro-
switch at the base of the fork is pressed in fully; the machine will start to operate and it will
only stop when the microswitch at the base of the fork is released.
6.4.5 PrOGrAMMING OF GrIND TIME
To programme the grind time of the machine, press together the
this manner you will enter into the programming mode and on the display will appear
the words "PROGRAMM. DOSES", the three dosage buttons will flash contemporarily
.
Once the dose to be programmed has been selected, the gauge will be set as shown in the
display below, with the time expressed in seconds (top right of the display). The characters
on the line at the bottom of the display concern the keys below:
Refers to the (-) symbol and reduces the grind time.
Refers to the word "TEST" and by pushing this button at this time will cause an immediate test
of the time programmed (with microswitch at the base of the fork completely pressed in).
Refers to the (+) symbol and increases the grind time.
mythos
CHOOSE DOSE
BARISTA
1.35 sec
keys it is possible to reduce or increase the dose, respectively; this
and the appliance will be set as indicated here
CONTINOUOS
PROGRAMM. DOSES
- +
buttons. In
15