Universal Cutter; After Using The Appliance; Sample Recipe For The Universal Cutter; Cleaning And Maintenance - Bosch MultiTalent 8 MC812 Serie Gebrauchsanleitung

en

Universal cutter

10. Insert the mains plug. Set the rotary
switch to the desired setting.
■ Add the food to be processed to the
filling shaft and push down with the
pusher, applying light pressure. Cut up
beforehand if necessary.
Caution!
Empty the bowl in good time:
– after processing max. 500 g,
– before the cubes reach the lower
edge of the dicer.
Emptying the bowl
■ After processing, set the rotary switch to
P. Disconnect the mains plug.
■ Rotate the lid anti-clockwise and
remove.
■ Fit the blade guard.
■ Take the dicer out of the bowl.
■ Rotate the bowl anti-clockwise and
remove. Empty the bowl.
■ Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 26
Universal cutter
For cutting up small quantities
of meat, hard cheese, onions,
parsley, garlic, fruit and vegetables. It
is not permitted to cut up coffee beans,
peppercorns, sugar, poppy seeds and
horseradish.
W Risk of injury
Do not remove / attach the universal cutter
until the drive has stopped. Do not touch
the blades of the blade insert with bare
hands. Never reach into the jug of the
universal cutter! To remove chopped food,
use a suitable implement (e.g. spoon).
Caution!
The universal cutter will not operate until
the lid is screwed on tight.
X Fig. K
1. Attach the jug. Observe the
marking (.) when doing so. Rotate the
jug clockwise as far as possible.
2. Add ingredients.
26
3. Attach the lid and rotate clockwise. The
lid lug must be fully inserted in the slot
of the jug.
4. Insert the mains plug. Turn the rotary
switch to setting M and hold.
Note: The longer the appliance remains
switched on, the finer the ingredients will
be cut. With herbs the desired cutting
result may be achieved very quickly after
switching the appliance on. A brief "tap" on
setting M may be sufficient.
■ After processing, release the rotary
switch. Disconnect the mains plug.

After using the appliance

■ Rotate the universal cutter anti-
clockwise and remove.
■ Turn the universal cutter over, and the
chopped food will fall into the lid.
■ Hold the lid. Rotate the jug anti-
clockwise and remove.
■ Remove the rest of the chopped food
from the jug using a suitable implement
(e.g. spoon).
■ Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 26
Sample recipe for the
universal cutter
Honey and hazel nut spread
– 10 g hazelnuts
– 100 g honey (room temperature)
■ Put the nuts in the universal cutter jug
and grind for 5 seconds on setting M.
■ Add honey and process for 10 seconds
on setting M.
Note the recomended processing quantities
and times. X Fig. O

Cleaning and maintenance

The appliance requires no maintenance.
Thorough cleaning will guarantee a long
service life.