Adjusting The Airflow; Maintenance And Cleaning - Parkside PDFP 500 B2 Originalbetriebsanleitung

Adjusting the airflow
GB
NOTE
► We recommend starting with the airflow set
to maximum. To do this, open the airflow
regulator
in the section "Increasing the airflow".
Increasing the airflow:
NOTE
► Increasing the airflow is generally advisable
if the dispersion is too coarse.
♦ Turn the airflow control
Decreasing the airflow:
NOTE
► Decreasing the airflow is generally advisable
if the paint mist is too strong.
♦ Turn the airflow control

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
NOTE
► Thorough cleaning after every use is very
important for safety and operation. Other-
wise, the needle could get blocked and
proper operation of the appliance cannot
be guaranteed.
■ Wear suitable gloves when cleaning.
■ Do not use any hydrocarbon-based solvents
like benzene, ethyl chloride, etc., as these could
trigger chemical reactions with some of the
materials in the paint spray gun. This can lead
to dangerous reactions.
6
to maximum as described below
anticlockwise.
clockwise.
CAUTION!
► Never immerse the paint spray gun com-
pletely in solvent.
■ After every use, squirt thinners (only outside
– risk of explosion!) or water through the
appliance.
♦ To clean the housing, the nozzle head
spray holes inside it, use the supplied cleaning
brush or a cloth. Never use petrol, solvents or
cleansers which can damage plastic.
♦ First, unscrew the stroke limiter screw
it in an anticlockwise
♦ Remove the spring
♦ Remove the needle
♦ Clean the needle
(see fig. B).
♦ Replace the needle
♦ Push the spring onto the end of the needle
♦ Screw the stroke limiter screw
it clockwise .
♦ Screw the flow cup
spray gun.
♦ Remove the filter
clean it with the cleaning brush.
♦ Also clean the inner screw thread
cup using the cleaning brush (see fig. D).
♦ Replay the filter in the spray gun (see fig. C)
and screw the flow cup
onto it.
♦ For rust protection purposes, you can spray a
little sewing machine oil through the spray gun
after cleaning.
♦ Oil all moving parts from time to time.
♦ After cleaning the needle, the thread and seal
must be lightly greased with a suitable lubricant.
♦ Do not use any silicon-based lubricants.
♦ Store compressed-air appliances only in dry
rooms.
and the
by turning
direction.
.
using pliers (see fig. A).
carefully with the brush
in the paint spray gun.
tight by turning
anticlockwise off the
as shown in fig. C and
of the flow
clockwise firmly
PDFP 500 B2
.