Maintenance; Maintenance Schedule - Husqvarna K 7000 Chain Bedienungsanweisung

Indication
2 green lamps flash.
3 green lamps flash.
3 green and 1 yellow
lamps flash.
3 green, 1 yellow and
1 red lamps flash.
All the status indica-
tion lamps flash.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional

Maintenance schedule

Maintenance

Clean the external parts of the product.
Do a general inspection.
Lubricate the diamond chain and the guide bar to prevent corrosion.
Do a check of the water system.
Make sure that the power trigger and the power trigger lockout operate correctly
from a safety point of view.
Do a check of the hand guard, rear hand guard, transmission cover and spray
guard.
1455 - 003 - 03.03.2020
Cause
The power output is 70-90 % of the maximum available
output in operation.
The cutting speed is at its best performance.
The power output is 90 % of the maximum available out-
put in operation.
The power output drops.
The product is too hot.
The product is too hot.
The power is decreased.
The system is in automatic shutdown.
Maintenance
Step
N/A
N/A
Decrease the load.
Decrease the load or increase
the water flow or airflow to de-
crease the temperature.
Decrease the load or increase
the water flow or airflow to de-
crease the temperature.
Increase the water flow or airflow
to decrease the temperature.
Put the power pack in a location
with lower temperature.
Refer to the operator's manual
for the power pack for more in-
structions.
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
Weekly or each
Daily
40 h
X
X
X
X
X
X
17