Start-Up; Power On / Off; Acoustic Signal - Parkside PLEM 50 B2 Bedienungs- Und Sicherheitshinweise

Remove the used batteries from the battery compartment
if necessary.
Insert the (new) batteries. Ensure the correct polarity as shown
on the diagram inside the battery compartment
Replace the battery compartment cover

Start-up



Power ON / OFF

Press power button
Press and hold the power button
off to power off the product.
Note: If no button is pressed for 3 minutes, the product will
automatically power off itself.

Acoustic signal:

- Each press of a button and every error-free function that is carried
out is confirmed by a short beep.
- A double beep will be heard in the event of any fault.
- Under continuous measurement mode, fast pace of short beeps will
be continuously heard and in the event of error, the fast pace
double beep will slow down.
- Briefly press the beep button
beep sound at any mode.
to power on the product.
11
11
to activate or deactivate the
13
.
5a
as shown (fig. A).
5b
until the LC display turns
,
5a
GB 15