Door Reversibility; Environmental Concerns - Zanussi ZRA934VW Benutzerinformation

Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the screw
head, then retighten the screws.
1. Remove the plinth.
2. Unscrew and remove the
lower hinges.
3. Remove the door.
7. Unscrew the pin (A) and
screw it on the opposite
side.
8. Remove the cap (B) and
position it on the opposite
side.
9. Screw the lower hinges.
10. Refit the plinth.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.

Environmental concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
18

Door reversibility

Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
To change the opening direction of the door, do these
steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the compressor
cannot touch the floor.
4. Unscrew the upper pin
and screw it on the opposite
side.
5. Refit the door.
6. Make sure the edge of the
door is parallel with the edge
of the top.
11. Stand the appliance up-
right.
A
12. Fit the handle on the op-
posite side and put the plas-
tic caps (contained in the in-
structions bag) in the free
B
holes.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate