Before Use; Fitting The Coil Spring; Inserting/Replacing The Soldering Tip - Parkside PLS 48 C1 Originalbetriebsanleitung

■ In case of danger, remove the plug from the socket immediately.
■ CAUTION! RISK OF POISONING! Avoid inhaling vapours!
■ During work over an extended period in which hazardous vapours
can be created, always ensure sufficient ventilation of the work-
place. In addition, protective gloves, a face mask and work apron
are recommended.
■ Avoid eating, drinking and smoking in rooms where soldering work
is taking place.
Otherwise, lead residues on your hands might contaminate the
food or cigarettes and be absorbed into your body.
■ Always wash your hands thoroughly after soldering.
■ Do not dispose of solder waste in normal domestic waste! Solder
■ waste should be disposed of with hazardous waste.

Before use

Fitting the coil spring

♦ Push the bracket of the coil spring
slot provided on the soldering station (see fold out page).

Inserting/replacing the soldering tip

CAUTION! RISK OF BURNS!
► Never heat the soldering iron
■ The soldering tip may only be removed when the appliance is
switched off and the soldering tip is cooled down.
■ The soldering tip has a screw thread and can thus be removed
quickly from the soldering iron.
♦ Unscrew the soldering tip anticlockwise.
♦ Screw the soldering tip in clockwise.
│ GB │ CY
■ 6
up to the stop into the
without a soldering tip .
PLS 48 C1