Original Accessories / Attachments; Before First Use; Fitting The Helical Spring; Inserting / Replacing Soldering Tips - Parkside PLS 30 Bedienungs- Und Sicherheitshinweise

Original accessories / attachments

Q
J
Use only the accessories detailed in the operating instructions. The
use of attachments or accessories other than those recommended
here could lead to you suffering an injury.

Before first use

Q

Fitting the helical spring

Q
j
Insert the narrower end of the helical spring
of the multifunctional holder
end of the helix points upwards and insert it into the recess provid-
ed for it in the multifunctional holder
j
Push the helical spring
j
Turn the helical spring
holder in place.
7

Inserting / replacing soldering tips

Q
CAUTION! DANgER OF BURNS! Allow the soldering
pencil to heat up without a soldering tip.
1. Insert a soldering tip
half of its shaft length.
2. Tighten the clamp screw
j
Remove the soldering tip only when the device has been switched
off and the soldering tip
Safety advice / Before first use
. Ensure that the outwardly bent
7
7
into the opening as far as it will go.
4
clockwise to fix the multifunctional
4
into the soldering pencil
2
using a Phillips screwdriver.
3
has cooled.
2
into the opening
4
(see arrow in Fig. C).
to a depth of
1
GB 13