Transport And Storage; Mounting And Installation; Mounting / Dismounting; Installation Conditions - Stahl 8602/3-Serie Handbuch

4

Transport and Storage

 Transport and store the device carefully and in accordance with the safety notes
(see Chapter "Safety").
5

Mounting and Installation

5.1

Mounting / Dismounting

 Mount the device carefully and only in accordance with the safety notes
(see Chapter "Safety").
 Read through the following installation conditions and assembly instructions carefully and
follow them precisely.

5.1.1 Installation Conditions

DANGER! Explosion due to the sealing of the device being too strong or defective!
Non-compliance may result in serious or even fatal injuries.
 Observe the specified (maximum) enclosure wall thicknesses.
 Install the device based on the dimensional drawings
(see Chapter "Attachment B").
Ensure that the dimensions are carefully observed.
 Observe specified tightening torques.
 Only install actuators up to a wall thickness of 5 mm/0.197 in, and rotary actuators with
radial drive only up to a wall thickness of 3 mm/0.118.
 Do not use actuators with LED indicator lamps (series 8010/x-xx-ws).
 Only use actuators in NEC version with particular special accessories,
see Chapter 5.1.8 and 5.1.9.
5.1.2 Actuator Mounting
 Ensure correct fit of the seal (4).
 Align the actuator (5) with the punch pattern in the installation wall (3).
 Tighten the jam nut (2) with the special wrench (1)
(tightening torque 3 Nm/26.55 lbf-in).
229711 / 8602612300
2019-11-14·HB00·III·en·02
Transport and Storage
Actuators
Series 8602/3
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
17578E00
7