Environmental Concerns - Electrolux ST401SCN10 Benutzerinformation

58 electrolux
15. Remove the handle. Unscrew the top
handle bracket from the handle rod
(h1). Unscrew the bottom handle
bracket from the door (h2). Unscrew
the top handle bracket from the door
(h3). Install the plug (A).
h1 h2
16. Install the handle in the opposite side.
Re-screw the handle bracket on the
door (h4). Turn the handle bracket with
the handle and screw them to the door
(h5) and the fitted handle bracket (h6).
h4 h5

ENVIRONMENTAL CONCERNS

The symbol on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will
help prevent potential negative
17. Install the lower door.
18. Install the middle hinge (H) in the oppo-
19. Install the upper door.
20. In your documentation bag you will find
h3
21. Make sure that the front board of the
22. Reposition, level the appliance, wait for
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabi-
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
h6
the cabinet. In that case, wait for the natural
fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the re-
versibility of the doors at your cost.
consequences for the environment and
human health, which could otherwise be
caused by inappropriate waste handling of
this product. For more detailed information
about recycling of this product, please
contact your local council, your household
waste disposal service or the shop where
you purchased the product.
site side.
the upper hinge necessary to make the
reversibility. Put the hinge in position
and screw it.
door is parallel to the front board of the
top.
at least four hours and then connect it
to the power socket.
net.