Axis Q16 serie Installation Seite 27

Buttons
Control button
For location of the control button, see Product overview on page 8.
The control button is used for:
• Enabling the Focus Assistant. Press and very quickly release the control button.
• Resetting the product to factory default settings. See page 23.
• Connecting to an AXIS Video Hosting System service. To find out more about this
service, see axis.com
Function button
Note
Focus assistant is only valid for optional P-iris, DC-iris or manual iris lenses.
Use the function button to activate the following functions:
Leveling assistant - This function helps to make sure the camera is level. To start the leveling
assistant, press the button for about 3 seconds. Press again to stop the leveling assistant. The
status LED and buzzer signal assist leveling of the camera, see Status LED behavior and buzzer signal
for leveling assistant on page 26. The camera is level when the buzzer beeps continuously.
Focus assistant - This function is used for enabling the focus assistant. To enable the focus
assistant, press and very quickly release the button. Press again to stop the focus assistant.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NO NO TICE TICE TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic compatibility (EMC) on page 4.
Audio connector
• Audio in – 3.5 mm input for a mono microphone, or a line-in mono signal (left channel
is used from a stereo signal).
AXIS Q16 Network Camera Series
27
EN