Emptying The Product; Storage, Cleaning - Playtive Junior PIRATAS Gebrauchsanweisung

Sequence
WARNING!
Follow the sequence below when
inflating the air chambers. Always fully
inflate all air chambers!
1. Lower air chamber (1a)
2. Upper air chamber (1b)
3. Superstructure (1c)
4. Prow (1d)
5. Mast (1e)
6. Control stand with ship's wheel (1f)
7. Mounting and cannon (1g)
8. Sword (2)
3. Inflation
1. Fill the lower and upper chamber (1a) (1b)
with air and close the cap (fig. B).
Inflate the air chambers until they feel firm.
When you press each air chamber with your
thumb, it should still give a little.
2. To fill components 3-8 open the valve seal
and inflate the air chambers. Close the valve
seal and push in the valve by pressing lightly
(fig. C).
Note: For better positioning first fill the bases
for the mast (1e) and the control stand (1f) with
water, and then fill them with air afterwards.
Before filling with air, put the ship's wheel onto
the control stand (1f) and pull the mounting
sideways over the cannon (1g). Then put the
mounting onto the pin of the upper air chamber
(1b).
4. Connecting the garden hose
Use a garden hose with a suitable hose coupling
and connect it to the water supply for the pro-
duct (fig. D).
Filling the product with water
Fill the product slowly and do not leave it unat-
tended while it is filling.
Always fill the product up to the marking indi-
cated.
Important! Observe the filling capac-
ity of 460l without the cannon being
connected!
18 GB/MT

Emptying the product

Open the drain hole and allow the water to run
out (fig. E).
Note: Please adhere to the local provi-
sions for specific regulations regarding
the disposal of water from swimming
pools.
Dismantling
Let the product dry completely before folding up.
Take off the garden hose. Take off all removable
individual parts.
Vent the product as follows:
1. To let air escape quickly from the lower and
upper chambers (1a) (1b), open the seal (fig.
F).
2. To let air escape from other components, pull
the valve out and squeeze the valve stem
lightly so that the air can escape.
Repairs
Small leaks or holes can be repaired using the
repair patch provided.
Important!
Do not inflate the product for 20 minutes after a
repair! Do not use the patch for leaks or holes
on the seam.
1. Allow the air to escape fully from the product.
2. Clean the area around the leak thoroughly.
The area must be dry and free of grease.
3. Cut out a piece of repair material big enough
so that the edges protrude approximately 1.3
cm over and beyond the damaged area.
4. Strip the patch from the paper, place it on the
damaged area and press it down firmly.

Storage, cleaning

Change the water in the product frequently, es-
pecially in hot weather and if it is dirty! Always
store the product at room temperature, clean,
dry, and uninflated. During storage the valves
should always be closed. Clean only with water
or soapy water, never with abrasive detergents.
When storing for the winter do not place any
sharp-edged objects on the product and do not
powder with talc.